Replacing the Fuses

Fuses on the vehicle's left side

  1. Open the fuse panel cover.

     

Removing/Installing fuses on the vehicle's left side

  1. Make sure the vehicle power is switched off, and other switches are off.

  2. Remove the fuse puller provided on the fuse block located in the engine compartment according to the following procedure.

    1. Open the hood.

      Refer to How to Use the Hood (Search).

    2. Disengage the rear lock by pressing down on the front tab with your fingers.

       

    3. Remove the front tab while slightly lifting the front of the cover.

       

    4. Remove the cover while lifting it and sliding it to the rear.

       

    5. Remove the fuse puller

       

  3. Pull the fuse straight out with the fuse puller.

     

  4. Inspect the fuse and replace it if it is blown.

    1. Normal

    2. Blown

     

  5. Insert a new fuse of the same amperage rating, and make sure it fits tightly. If it does not fit tightly, have an expert install it. Consult an Authorized Mazda Dealer.

    If you have no spare fuses, borrow one of the same rating from a circuit not essential to vehicle operation, such as the audio or accessory socket circuit.

     

    Always replace a fuse with a genuine Mazda fuse or equivalent of the same rating. Otherwise, you may damage the electric system.

    Close Caution
    View Caution

  6. Reinstall the cover and make sure that it is securely installed.

Fuses under the hood

Contact an Authorized Mazda Dealer for replacing the fuses under the hood.

Page top