Tilt/Slide Operation
The panorama sunroof can be opened or closed electrically only when the ignition is switched ON.
-
Before leaving the vehicle or washing your Mazda, make sure the panorama sunroof is completely closed so that water does not get inside the cabin area.
-
After washing your Mazda or after it rains, wipe the water off the panorama sunroof before operating it to avoid water penetration which could cause rust and water damage to your headliner.
Tilt Operation
The rear of the panorama sunroof can be tilted open to provide more ventilation.
When pressing the tilt/slide switch 1 time, the sunshade opens a quarter of the way and the rear side of the front panorama sunroof glass opens upward.
When pressing the tilt/slide switch forward 1 time, the panorama sunroof closes.
The sunshade can be fully opened by pulling the tilt/slide switch rearward 1 time with the panorama sunroof tilted. To close the sunshade and the panorama sunroof from this condition, press the tilt/slide switch forward 2 times.
-
Tilt up
-
Close (Tilt down)
Slide Operation
When pulling the tilt/slide switch rearward 2 times, the sunshade and the panorama sunroof open.
When pressing the tilt/slide switch forward 2 times, the sunshade and the panorama sunroof close.
-
Open
-
Close
-
If you want to tilt the panorama sunroof, first close the panorama sunroof and then do a tilt operation.
-
When the sunshade is open, the panorama sunroof can be opened/closed with 1 rearward/forward operation.
-
If the panorama sunroof does not operate normally, do the following procedure:
-
Switch the ignition ON.
-
Press the tilt switch to open the rear side of the front panorama sunroof glass upward.
-
Repeat Step 2. The rear of the panorama sunroof tilts open to the fully open position, then closes a little.
If the reset procedure is performed while the panorama sunroof is in the slide position (partially open) it will close before the rear tilt opens.
-
