Spare Tire and Tool Storage
Changing a Flat Tire

Changing a Flat Tire

 


If the following occurs while driving, it could indicate a flat tire.

  • Steering becomes difficult.

  • The vehicle begins to vibrate excessively.

  • The vehicle pulls in one direction.

Close Note
View Note

If you have a flat tire, drive slowly to a level spot that is well off the road and out of the way of traffic to change the tire.

Stopping in traffic or on the shoulder of a busy road is dangerous.

 


Be sure to follow the directions for changing a tire:

Changing a tire is dangerous if not done properly. The vehicle can slip off the jack and seriously injure someone.

No person should place any portion of their body under a vehicle that is supported by a jack.

Never allow anyone inside a vehicle supported by a jack:

Allowing someone to remain in a vehicle supported by a jack is dangerous. The occupant could cause the vehicle to fall resulting in serious injury.

Close Warning
View Warning

 


Make sure the jack is well lubricated before using it.

Close Note
View Note
  1. Park on a hard, level surface off the right-of-way and firmly set the parking brake.

  2. Shift into Park (P) and turn off the engine.

  3. Turn on the hazard warning flasher.

  4. Have everyone get out of the vehicle and away from the vehicle and traffic.

  5. Remove the jack, tool, and spare tire (Search).

  6. Block the wheel diagonally opposite the flat tire. When blocking a wheel, place a tire block both in front and behind the tire.

     


    When blocking a tire, use rocks or wood blocks of sufficient size if possible to hold the tire in place.

    Close Note
    View Note